Both the 50mm and 70mm options of the Perry Long throw gate locks feature the same specifications – the only difference is the thickness of door or gate that they fit to!
They both feature 65mm of throw from the marine grade stainless steel locking bolt, all fixings for attaching the long throw locks to the gates are also stainless steel which gives extra protection against corrosion.
5 keys are supplied with every Perry long throw gate lock and best of all it is key lockable from both sides.
Keyed Alike Versions
Keyed alike versions of the long throw gate locks are also available, this allows you to open several of the long throw gate or door locks with the same key. If ordering the keyed alike version there is a minimum order quantity of two.
What Size To Get?
The 50mm and 70mm options refer to the thickness of the door or gate you are installing the gate lock upon. If your gate or door is 50mm or less in thickness then the 50mm version of the long throw lock is required. If your door or gate is greater than 50mm thick but 70mm or less in thickness then the 70mm version of the gate lock is required.
Looking for a version that has a latch on the rear for ease of access, then check out our single locking gate and door locks out.
Each Double Locking Long Throw Lock comes with the following:
- Solid Brass Escutcheon plate (with brass screws)
- Stainless steel screws (for attaching the body of the lock)
- Handles available as optional extra
- 28mm spade drill bit as optional extra
- Full fitting instructionsWe’ve also produced a fitting guide for the Perrys long throw locks which can be found here