Perry Hooks to build for 9 inch brickwork
Sold in pairs, the hooks to build are suitable for use with 9 inch (225mm) brick/blockwork (double skin).
Used when you intend to hang gates from brickwork or blockwork pillars, the hooks to build are built in as the pillars are built and bedded in mortar between courses of your brickwork.
Available in a choice of three pin sizes, 11mm ( 7/16"), 19mm (3/4") and 22mm (7/8").
11mm and 19mm pin sizes of the hooks to build are available in a hot spelter galvanised finish, the 22mm version is only available in a self colour finish.
19mm hinge pin on 100mm square plate
Fieldgate hook to bolt 325mm long 19mm pin galvanised
325mm / 13" Hook to bolt to suit posts 4" to 10" thick.
19mm pin to suit any of our field gate hinges.
Hook to bolt fits to a pre-drilled hole through the post, then secures by way of bolt on rear side of post. The hook to bolt can only be used if you have access to both the inside and outside faces of the gate posts.
Hot spelter galvanised finish.
The hooks to bolt are supplied individually, if a pair are required then two must be ordered.
Perry Hooks to Build 11mm pin 115mm Brickwork self colour
Sold in pairs, the hooks to build are suitable for use with 4 1/2 inch (115mm) brick/blockwork (single skin).
Used when you intend to hang gates from brickwork or blockwork pillars, the hooks to build are built in as the pillars are built and bedded in mortar between courses of your brickwork.
Available in a self colour finish with an 11mm pin.