Woodworking joints – Joining timber in width
This type of joint enables narrow boards to be built up to cover large areas (floor boards, cladding, etc.), or built up to form wider boards for shelving, cabinet work, table tops, etc.
Tag Archives: joining timber
Woodworking joints – Angle joints part 2
Woodworking joints can be divided into three main classifications that correspond to their functions. Joints for increasing the width or surface of timber
Joints in length for increasing the lengths of timber,
Joints in width for increasing the width of timber,
Angle joints.
Joints in length
This type of joint is used where the required length of timber is unavailable. The four main types are:
Scarf joints, Laminated joints, Heading joint and Handrail bolt.
Joints in width
This type of joint is used to form wider boards for say work/counter tops, cabinet work or shelving or to enable narrow boards to cover larger areas such as flooring or cladding.
Angle joints
This group of joints is a broad one and covers a large variety of joints, such as mitre joint, halving joint, mortice and tenon, dovetailing, housing, bridle, etc.
In part one we shall be looking at angle joints.
Basic Woodworking Joints
The main aim when jointing any pieces of timber together should be to cut the joints and arrange them so as to weaken the pieces of timber as little as possible. When the connection is effected entirely by means of timbers fitted together, it is called a joint. Most commonly, however, the joint is strengthened and secured by fastenings, such as: wedges, glue, draw pins, pins, screws, nails, etc. In nearly all cases simple joints are more effective than complicated joints.
Woodworking joints can be divided into three main classifications that correspond to their functions:
joints in length for increasing the lengths of timber, joints in width for increasing the width of timber and angle joints.